Guide：Barrel temperature in meeting production quality under the premise, as far as possible to reduce, or maintain the Ju moderate in the first section of the main temperature unchanged, to lower the following section temperature; fusion line position to change if a couple of plastic injection, then pay attention to adjust the position, so that the fusion line is not easy to break.

2, with HIPS material of the product outlet is easy to pull high.
        Guide：If there is no guarantee, then increase the pressure, the original there is a pressure to increase the pressure, the principle is a high pressure, the speed is slow (small), holding time 1~2 seconds.

3, with the PP material product easy to produce the flying edge and shrink.
　　Guide：Reduce the flying side principle, reduce the injection pressure, increase the speed; fly in the middle of the product, the mold increases the support column, in the product (around the middle is not flying). The machine can increase the clamping force, or for large tonnage machine production, or to open the exhaust. A few of the same product, the middle of the product to produce flying, the above method is not effective, can reduce the intermediate product into the rubber mouth (or flow). The position of the product in the position of the position of the shot put the glue at the speed. Material temperature lower, in the product without the premise of flying, can be added into the rubber mouth.
4, with PA material of the product material flowers, yellow.
        Guide：Material drying time to long (4 hours) and production do not arbitrarily shut down, cut off the water supply to the barrel material shot; Ju Wen can not be high (Ju Wen Gao Yi plastic flow), barrel temperature is high, not completely dry, easy to produce "water" phenomenon and yellow.

5, with PVC material attention.
       Guide：The surface is not smooth, there are miscellaneous grain, can be used to bake at 55~60 for 2 hours, down (including temporary). The best use of PP material cleaning barrel, avoid PVC decomposition carbon inside the barrel, dark spots. The machine screw is best to use a special screw.

6, PC material debugging.
        Guide：In principle, the pressure is small, the speed is quick, try not to keep the pressure.

7, ABS extraction aggregate white mist, silver, spray.
        Guide：Low temperature melt barrel, slow speed, drying time should be long (preferably with a 2 material drying machine drying).

8, POM material debugging.
　　Guide：When the surface of the product is smooth, the temperature of the mold is 55~70. Raw materials for 60 degrees Celsius temperature drying. Production can not stop at random, easy yellowing.